Ⅰ . Overview Type DB-63 single line grease pump applies to the small sized single line grease centralized lubricating system with relatively lower lubricating frequency, lubricating points under 80 and PN of 10Mpa. It is a supplies and delivers lubricating grease to each lubricating point...Send Inquiry
Ⅰ . Overview
Type DB-63 single line grease pump applies to the small sized single line grease centralized lubricating system with relatively lower lubricating frequency, lubricating points under 80 and PN of 10Mpa. It is a supplies and delivers lubricating grease to each lubricating point through a piece-type grease feeder.
Type DBZ-63 single line grease pump can be used for the lubricating points with relatively longer lubricating cycle or of relatively disperser equipment. Lubricating grease is filled directly by a grease feeding gun. It is especially suitable for the transportation machinery equipment used in ports and docks.
Ⅱ . Technical parameters
Nominal pressure (MPa)
Rated flow (ml/min)
Volume of grease storage (L)
Diameter of plunger (mm)
Number of plunger
Use grease with cone penetration 250~350(25℃，150g) 1/10mm (NLGI0#~2#).
Ⅲ . Descriptions of model
Ⅴ . Dimensions
Ⅵ . Use instruction
This type single line grease pump should be installed in the place with appropriate environmental temperature and less dust for the convenience of grease supplementing, adjustment, inspection and repair & maintenance.
Add 1 liter 50# mechanical oil to the reduction gearbox before use.
Supplementing grease into grease conservator must be done by using SJB-D60 manual grease filling pump or DJB-200 electric grease filling pump from the grease inlet of the grease conservator. It is strictly forbidden to start grease pump when there is no lubricating grease in the grease conservator.
Connect the motor in accordance with the rotation direction indicated on the fan shell of motor. Reversal is forbidden.
The filter screen of grease inlet should be washed regularly.
The pressure regulating value on the pump body can be adjusted arbitrarily within the scope of 0~10Mpa which should not exceed the PN 10Mpa of pump is use.
When the pressure of pump fluctuates or grease supply is abnormal, the air discharge screw on the pump body can be loosened. When air is discharged and grease spills over normally, the air discharge screw can be tightened immediately.
Single line grease pump should be kept clean. Opening the cover to supplement grease is strictly forbidden for avoidance of dirty substance to enter pump body and influencing normal working.